![]() ![]() Therefore, if you are replacing the systems battery (in the trunk) you need to disconnect the negative battery cable from the starter battery (under the hood). On vehicles with two batteries (starter battery and systems battery), usually S-class (221) and SL class (230/231) the starter battery needs to be connected first.This is where the systems battery will be located. Once the bolts are removed and the bottom panel comes out, the forward most panel will pivot out from the left side (right side pivoting) and slide out to reveal a space between the forward-most trunk panel and the back of the seat. The trunk bottom panel has two T20 Torx bolts that sit inside the black plastic hooks bolted to the floor of the trunk. On the S-Class or AMG S-class (2010 or later) there is a panel at the forward most part of the trunk that can easily come out with the removal of the trunk bottom panel. In some cases, there is a strap wrapped around the battery that can be loosened by finding the buckle, usually located on the side of the battery. On vehicles with the battery in the trunk, you need to lift up the trunk floor panel and the battery should be on the right or center of the trunk under compartment.Although some batteries may seem shoehorned into their respective place, push all cables and wires to the side and lift straight up. use a screwdriver and pop them upward and removed air filter box. There are three snap clips on top that hold it to the firewall. Additionally you may need to remove the cabin air filter box. A 13mm socket and extension are required to remove battery bottom mounts. On vehicles with exposed batteries (under the hood), a 10mm wrench or socket is required to remove battery cables and battery top mounts. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |